DA only?

Info, pictures, advice...
Post Reply
Daddyursus
Junior member
Posts: 20
Joined: August 18th, 2013, 11:50 am
Location: Maryland

DA only?

Post by Daddyursus »

I picked up my final P-64 yesterday from my FFL. ( I live in Maryland and in a few weeks we will have some of the wrong gun laws in the country) It is a beautiful '76 model with excellent finish and wooden grips. So I immediately field stripped it to check for oil and then headed to my clubs outdoor range for an ops check. The trigger feels like it has had work done to be a lighter pull. The previous owner has no history on it. Well, it fired and reloaded, but the hammer did not set for single action. I cocked the hammer and again a good fire with the hammer rest to DA. Has anyone knowledge about this? I'm a new P-64 owner and have experienced many adventures in ownership.
Thanks for all help
snailman153624
Senior member
Senior member
Posts: 291
Joined: May 16th, 2012, 10:14 pm

Re: DA only?

Post by snailman153624 »

...so are you saying that the hammer stays cocked but won't fire with a trigger pull, or that it immediately falls without a trigger pull?
Daddyursus
Junior member
Posts: 20
Joined: August 18th, 2013, 11:50 am
Location: Maryland

Re: DA only?

Post by Daddyursus »

snailman153624 wrote:...so are you saying that the hammer stays cocked but won't fire with a trigger pull, or that it immediately falls without a trigger pull?
It immediately falls without a trigger pull. It's like it goes through a decocking mode. And maybe that's the answer. Something is wrong with the safety lever mechanism.
snailman153624
Senior member
Senior member
Posts: 291
Joined: May 16th, 2012, 10:14 pm

Re: DA only?

Post by snailman153624 »

Sounds dangerous (slam-fire like scenario comes to mind). Take the grips and slide off, and observe what it's doing when you try to cock the hammer.
Daddyursus
Junior member
Posts: 20
Joined: August 18th, 2013, 11:50 am
Location: Maryland

Re: DA only?

Post by Daddyursus »

Thanks for the advice snailman, the problem is I'm not sure what I'm looking for :-)
snailman153624
Senior member
Senior member
Posts: 291
Joined: May 16th, 2012, 10:14 pm

Re: DA only?

Post by snailman153624 »

When you cock the hammer, there is a small notch/spur on the bottom of the hammer that's supposed to catch the sear; you should be able to see why it's not catching.
User avatar
Weasel640
Forum supporter
Forum supporter
Posts: 680
Joined: March 13th, 2010, 9:14 pm
Location: Nothing permanent.

Re: DA only?

Post by Weasel640 »

Could be that your disconnector is not functioning properly. I know you don't know the history but if it has been replaced it may need fitting as often times the new disconnectors come a hair to tall.

Here is a thread on troubleshooting the disconnector:
viewtopic.php?f=3&t=4105&view=next

NOTE: if you remove to much material from the disconnector, your safety will stop decocking or worse.
Weasel

When you vote, you are exercising political authority, you're using force. And force my friends is violence.
Daddyursus
Junior member
Posts: 20
Joined: August 18th, 2013, 11:50 am
Location: Maryland

Re: DA only?

Post by Daddyursus »

Weasel640, YOU ROCK !!!!!!!
Post Reply