The Unofficial P64 Resource Forum

Could it be that your flinching? It's easy to do with a gun that bites like the P64. Denny You know Denny you may be on to something... :shock: After reading several articles on flinching I sure do brace myself a bit more before I squeeze the trigger on the p64. I am so much more accurate with my o...

know the front sight is machined as part of the slide. My front sight is approx. .080" high measured at the rear of front sight down to flat cut. The top of my front sight appears level with the cut front to back. Does it look like any "custom" work down here? The crown of my rear si...

Curly1 wrote:Are you shooting 1 handed, 2 handed standing?

From a bench with a rest?

All of the above?

How does it shoot up close say 10 feet or less is it right on then?

2 handed standing

I will give the 10 ft shot(s) a try next range visit.

Thanks Curly1

~ Say_What_Again

Ward223 wrote:Is there a gap under tbe rear sight wear it not solidly in the bottom of the groove???

It's solid, no gap...Besides this would only adjust right to left (windage) not elevation.
There is no elevation adjustment on the P64 that I know of.
The elevation is my biggest concern.

~ Say_What_Again

Ward223 wrote:Have you adjusted the sight yourself???

Hi Ward223

No I have not & from what I read it's a bear to do that right to left & vise versa.

Besides, it's the 6 to 8 inches low that has me most concerned.

The right is an inch or 2.

Regards,

~ Say_What_Again

Hello to the good members of this forum ... :hi: I am a C&R/firearm junkie ~ Several Mosin's, SKS's, & odds & ends. I wanted to make an educated C&R pistol purchase & a while back I started lurking. The DA hype & recoil of the P64 had me somewhat concerned, however, there are...