Wont decock after new hammer spring install

Mods and Fixes by P-64 users...
Post Reply
ronj10
Posts: 1
Joined: November 6th, 2018, 8:23 am

Wont decock after new hammer spring install

Post by ronj10 » November 6th, 2018, 8:46 am

Hello,
I am new to the forum.
I have my first P64 and put in a wolf 17 lb hammer spring.
I really like the new DA pull with this spring.
However,
When I rack the slide, which cocks the hammer, I have to flip the de-cocker lever several times before it drops the hammer (decocks).
It worked fine before I installed the new hammer spring.
This may have been covered already in the forum, but after looking through it I could not find anything.
This is a big forum.
Is there a thread that addresses this issue?
Thanks

Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests