Safety Tempering
Re: Safety Tempering
Please let us know how the fit and function is.
Close enough for Government work will get you dead, ask any Vet.
-
- Veteran member
- Posts: 650
- Joined: November 19th, 2006, 8:28 pm
- Location: michigan, down the river
Re: Safety Tempering
Let us know for sure.
Re: Safety Tempering
Will do, now I'd just like to find a trigger bar to have on hand. Just for a Just in case need for it.
Re: Safety Tempering
Looks like two have been sold at full price, and two have been sold at an offer price. I wonder what his bottom line is for offers. I wonder if once they are all sold he'll tell us where/by whom they were made.
Weasel
When you vote, you are exercising political authority, you're using force. And force my friends is violence.
When you vote, you are exercising political authority, you're using force. And force my friends is violence.
Re: Safety Tempering
I would offer $40 and see what happened if I was interested.
Laugh Hard and Often.
Gary
Gary
Re: Safety Tempering
I did 40 and it was declined, had to go to 45
Re: Safety Tempering
That would have been my next offer also do 45 looks like his bottom line I would say.
Get em while they last.
Get em while they last.
Laugh Hard and Often.
Gary
Gary
Re: Safety Tempering
Good news, I got mine yesterday, looks really nice. Bad news installed it and the firing pin gets hung up in the fired position, fully extended. If you bump the safety ever so slightly toward the safe position the firing pin will fully retract on it's own. With out digging out the calipers and getting all scientific, my guess by eye balling it is the machined in detent looks just a bit off. So when the safety is at rest in the full off position it is just a bit too far "off" so to speak. But it looks to be a nice job machining, which is a shame. I'm going to putz with it see if I can make it function.
So be careful and check yours if you bought one.
So be careful and check yours if you bought one.
Re: Safety Tempering
Let us know what the fix is.
Close enough for Government work will get you dead, ask any Vet.
Re: Safety Tempering
Well that was quick. Dragged out the evil Dremel tool with a diamond small point bit. Cut the edge of the safety where the pin had the small tab off the side of recesses into the safety seemed to be ever so slightly a lip there. And took a couple of touches to the detent on the opposite side that I wanted to move the safety. It functions very nicely now. The effort to make it click into position are a bit less than the original which for this one I tried it on is ok, they were pretty stout before. So five minutes in at the bench to get it to work is ok with me. Happy I bought it, I'll have to figure out how to post pictures here and show what they look like.