I am going to start converting 9x19 to 9x18 cases. Would this be the proper sequence:
1. Tumble.
2. Deprime/case shaper with 9x18 die.
3. Expand to accept 9x18 size (.365) bullet.
4. Trim case to 9x18.
5. Charge case.
6. Seat bullet
Is this the sequence to use?
Thanks
I am confused with the sequence
-
- Global moderator
- Posts: 3575
- Joined: February 26th, 2006, 6:59 am
- Location: LAKELAND FL.
Re: I am confused with the sequence
3. Expand to accept 9x18 size (.365) bullet.
4. Trim case to 9x18.
changes these steps to it should work better
.
3. Trim case to 9x18.
4. Expand to accept 9x18 size (.365) bullet
NORM
4. Trim case to 9x18.
changes these steps to it should work better
.
3. Trim case to 9x18.
4. Expand to accept 9x18 size (.365) bullet
NORM
NORMSUTTON@AOL.COM
N.R.A. LIFE MEMBER 1976
N.R.A. LIFE MEMBER 1976