Page 1 of 1

Back to OEM hammer spring

Posted: November 29th, 2016, 9:39 am
by culpeper
After going through a box 1000 Brown Bear I decided to go back to the original hammer spring and learn myself to shoot SA. 18# spring creates just enough hair trigger. Legally, especially in my state, every shot fired can be called into evidence as well as mods made to the weapon. The light trigger pull is best left to the expert shooter, which I am not. I can see the court explaining how the shooter fired half his rounds no where near the target and it just goes from there. IMO only. I don't see a problem shooting in the OEM configuration with practice. It just makes sense for me on various safety and liability levels.

Sent from my E6782 using Tapatalk

Re: Back to OEM hammer spring

Posted: April 14th, 2017, 11:10 am
by OG17
I know this is a bit old, but I did the same thing for the exact same reason.