Russ Grip Ver3 Redux
Posted: October 18th, 2015, 12:08 pm
I already emailed Russ about this but after doing the Dremel work on my ver4 grip to let the trigger reset I did the same (from scratch since ver3 was smooth...) using the original R/H grip as a template and made ver3 USEABLE!!! If you ream out the area same as the ver4 grip and/or the original grip's area, the ver3 will work like it should. I had mag release issues, too, so took care of those while at it and all is well.
At least it did for me so now I have 2 sets instead of the one....
At least it did for me so now I have 2 sets instead of the one....