Page 1 of 1
Can't replace the slide to the frame
Posted: February 8th, 2015, 5:00 pm
by Retiredin2001
I am having trouble replacing the slide to the frame the slide isn't lower to be even to frame with the spring on it jumps over. Even tried to installed it with out the spring it seems tiled up and not level Has anyone else had this problem
Sent from my iPhone using Tapatalk
Re: Can't replace the slide to the frame
Posted: February 8th, 2015, 11:01 pm
by gemini1
Make sure the slide stop lever is in its proper position. As long as you're using the same recoil spring, then this is the only part that will keep the slide from going all the way back and in the frame if it's not in proper spot.
Re: Can't replace the slide to the frame
Posted: February 8th, 2015, 11:38 pm
by Retiredin2001
Thanks all it needed was a little downward pressure.Replaced hammer spring and extra power recoil spring to the range
