The Unofficial P64 Resource Forum

Recently purchased a Daltech Force PP2 pocket holster for my P64. After wearing it for a week I noted that the gun fit the holster in a rather sloppy manner. This holster is designed for the Walther PPK among others of approximately the same size so I figured that the P64 would fit pretty good. After thinking about what to do with the holster I decided that a very simple fix would correct the problem. I stitched two small but very strong stitches three eights of an inch from the original stitching toward the trigger guard and now the gun fits as it should.

Click on full editer button on the bottom and then use the browse button to go to the pic on your pc.

Use add file button and repeat if multiple pics.

Do a preview to review and then submit.

To Curly 1,

Thanks for the info regarding loading photos. My problem was that the photos were too large in size to be loaded. After checking around I found that Windows Paint has a great application that will resize any photo and then will load without any problems. Thanks again.

Nice job looks like original stitching from the factory.