Page 1 of 1
RK.59 9mm
Posted: December 19th, 2011, 11:16 pm
by dskeetah
I have a Hungarian RK.59 9MM pistol. A dumb-ass stole my clip and left the pistol. I am wondering if anyone knows where I can find a 6-round magazine for this pistol.
Thanks,
Re: RK.59 9mm
Posted: December 20th, 2011, 12:10 am
by Curly1
Sorry to hear that, I hate thieves.
Re: RK.59 9mm
Posted: December 20th, 2011, 2:00 am
by juniustaylor
I read that a PA-63 mag will fit in the RK-59 but may hang out a tad. You may have to go that route. I saw a lot of warnings about shooting the RK-59 as they say the metallurgy is bad and the frame will break.
Re: RK.59 9mm
Posted: December 20th, 2011, 11:12 am
by dskeetah
Thank you. I will try finding that particular mag. Junius: it is an aluminum frame, and I am wondering if there is some truth behind that statement, regardin the metallurgy.
Re: RK.59 9mm
Posted: December 20th, 2011, 3:24 pm
by Curly1
There's some info here on them, not many made.
http://www.hungariae.com/FegRK59.htm
Re: RK.59 9mm
Posted: December 20th, 2011, 7:03 pm
by fully machined
CDNN has new two tone pa-63 mags for $19.95.
Re: RK.59 9mm
Posted: December 20th, 2011, 7:04 pm
by PA-Joe
It's going to be funny when someone tries to use those 9x18s in a 9mm!
Re: RK.59 9mm
Posted: December 21st, 2011, 12:08 pm
by lklawson
PA-Joe wrote:It's going to be funny when someone tries to use those 9x18s in a 9mm!
They'll probably jam up in the chamber or mis-feed. And that's if they even fit into the magazine.
But, yeah, could be potential kaboom.
Peace favor your sword,
Kirk
Re: RK.59 9mm
Posted: December 22nd, 2011, 12:10 am
by surfzombie
Just to clarify. Your Rk59 should be a 9mm Makarov or 9x18mm/ The PA-63 mags will fit but they will hang down at the bottom because they are a7 round mag. Any 6 round mag for the smc 918, smc380 or R61 should fit it like a glove. I would check on gunbroker.com
Re: RK.59 9mm
Posted: December 22nd, 2011, 12:55 am
by dskeetah
Surf:
Thanks a lot. I will look into that.