The Unofficial P64 Resource Forum

So I converted a buddies Saiga12 this weekend and found a brand new unopened pack of Wolff springs for a Polish P64 in one of my roll aways.. 20lb Recoil/firing pin and a 18lb hammer spring. Well all my P64's are all done...what to do?
Order another P64 of course

I'm gonna wear my UPS lady out!

Can't let those springs go to waste now can we?

No we cannot.
I also went a tad overboard and reloaded 10 boxes (500 rounds) of Mak over the past couple of weekends.

I went on a small reloading spree with Mak, Luger, and .243. My next project is 8mm Mauser. The dies should come in from Midway here in the next day or so.

You will really enjoy the 8mm.
I never had much luck with the 175g or 180g boolits frankly.
The 200g Speer runs great.
YMMV

Sarge, I chose the 150 grain Hornady Interlocks. I was reading reviews on Midway's website and there were gobs of folks that liked them. I didn't read anything negative. Some folks even posted their load info when you're really not supposed to. Shows that no one really reads those reviews before they're posted. I am thinking of converting .30-06 brass to 8mm brass. I currently have them all cut down but am waiting for my die set to show up today so I can try to form them. Any experience with this?

Well I look like Tampa Bays at bats against the Texas Rangers last night. I strike out on everything there!