Magazine release
Posted: December 23rd, 2008, 12:18 am
Have read every thread on entire message board, but this is my first post. I purchased a p-64 several months back. There were several issues that needed "fine tuning" on this particular pistol. One thing that was more difficult than I thought nessasary , for me at least, was getting my finger on the magazine release. To solve this I beveled the back of the plastic bottom by approximatly one fourth of the height, and then put a bigger radius on the three fourths height that was left. This helped quite a bit. Next I belled out the bottom of the plastic grips around the release button. This was actually little more than rounding off the sharp edges of the moulded grips. I dont know what others have thought of this but it worked for me. If I were going to use it as a carry piece I would consider it a good modification.