I goggled online but didn't find any. So maybe I should ask here.
Besides changing the hammer spring, to give your P64 a lighter pull. Has anyone done anything else to make it a little better than just a manageable DA trigger pull?
While waiting for the extractor I ordered in Poland, I'm thinking of doing a little more than just a light polishing on my P64.
I've already replaced the hammer spring to 18lbs. I dont think its wise to go any lower since it also affects the pull on single. And while I can now pull the trigger on DA, I still feel a heavy resistance, halfway through, its when the trigger bar engaging the sear/cut on the hammer.
Since a hammer replacement seems to be available at gun broker, I figured I start there, if I fail to give it a smoother pull.
If anyone has already done some kind of polishing, please post the how, what, where and if it did gave your pistol any noticeable change.
Thanks.
What else besides hammer spring, for smoother pull?
Re: What else besides hammer spring, for smoother pull?
I replaced the spring with an #18 as well. It was still almost impossible stiff, until I put about 50 rounds through her. Now she is tolerable.
Re: What else besides hammer spring, for smoother pull?
See my post here:
viewtopic.php?p=51403#p51403
Subject: Polishing Hammer and Hammer Strut.
Posted with SwiftKey
viewtopic.php?p=51403#p51403
Subject: Polishing Hammer and Hammer Strut.
Posted with SwiftKey
Re: What else besides hammer spring, for smoother pull?
Thanks pshootr. Yes I did more than that. I've updated the other thread and showed how Ive done it.