DA trigger pull extremely difficult

[sla011308]

I have read the message board regarding the difficult DA trigger pull. However, I have noticed something on my P64 that is different from the one my brother has. When I am having the difficulty pulling the trigger in DA, I noticed that my hammer does not go back as far as my brother's pistol does. I just received mine today, so I'm not sure that this will effect the way it performs. Has anyone noticed this, along with the extremely difficult trigger pull?

[rottenrick]

Is the hammer round or triangular?? I just got mine today as well. Get it from J&G?? It is tough, no doubt. But not nearly as bad as I thought it would be. I'm changing the hammer spring and recoil spring. I'll set you know.

[sla011308]

Is the hammer round or triangular?? I just got mine today as well. Get it from J&G?? It is tough, no doubt. But not nearly as bad as I thought it would be. I'm changing the hammer spring and recoil spring. I'll set you know.

[sla011308]

Sorry about the last reply, index finger not doing too well after trying to pull the trigger on my P-64. Yes, I asked specifically for the triangle shaped hammer. I did purchase from J&G and noticed that mine was the only one of the lot that had this issue. I don't think that the hammer is going back far enough to strike the pin and discharge the weapon. I haven't fired it yet, so I don't know for sure. I really like the size and weight of the pistol and hope that it isn't a difficult issue to resolve. I have already ordered my package to change out the hammer and recoil spring as well.

[rottenrick]

Just changed out the recoil spring. Would have changed out the hammer spring except my good 1/16 punch is missing. My number one suspect is in Iraq right now. I won't bother him over this right now. I'll buy a set of gunsmith tool kit in the AM, kind'a wish he was here so I could yell at him.