one more PA-63 question

Discussion with questions, answers, and everything else about all other 9x18's
Post Reply
3030tank
Posts: 5
Joined: January 31st, 2010, 11:05 am

one more PA-63 question

Post by 3030tank »

Can someone tell me how the pa63 "hammer release" works? The reason I ask is mine seems to move freely inside the gun. There is a pin on the right side of the gun on the same plane as this part, and there is a pin hole in the exact same spot on the left side of the frame, but the pin doesnt go all the way through, sorry for such an obscure question, I just want ot make sure my gun is safe. Thanks
mikeh1
Senior member
Senior member
Posts: 204
Joined: May 25th, 2007, 6:58 pm
Location: Van Nuys, CA USA
Contact:

one more PA-63 question

Post by mikeh1 »

if it's just above the top of the grip, mine is also like that
3030tank
Posts: 5
Joined: January 31st, 2010, 11:05 am

one more PA-63 question

Post by 3030tank »

Yeah thats where it is, odd that there is a place for a pin there, wonder if thats just so you can insert it from either side. hmm. Thanks though.
Stingray
Junior member
Posts: 26
Joined: June 5th, 2010, 10:08 am

Re: one more PA-63 question

Post by Stingray »

The pin/ pin hole arrangement is also the same on my PA-63.

-S
User avatar
chimera
Junior member
Posts: 41
Joined: January 24th, 2008, 8:18 am
Location: richmond va

Re: one more PA-63 question

Post by chimera »

The hammer release (shaped like a hawkbill) is held and rotates on the hammer pin.
The short pin in front of it holds in the fireing pin lifter in the center of the frame, it moves up with the sear when you pull the trigger.
Oh, when you put hte safe on it presses down on the hammer release and trips the sear.
Post Reply