I just picked this up at a show today and am looking for another mag. The P63 mags fit, but a bit long. Any ideas where to find one?
Also...what about springs? Can I use P63 hammer and firing pin springs, or will they be way off?
raz
FEG SMC 918
-
- Member
- Posts: 65
- Joined: May 6th, 2009, 6:14 pm
FEG SMC 918
I'd suggest looking here first: if you can't find it listed, call them: their inventory is pretty substantial.
http://www.e-gunparts.com/
http://www.e-gunparts.com/
-
- Global moderator
- Posts: 3575
- Joined: February 26th, 2006, 6:59 am
- Location: LAKELAND FL.
FEG SMC 918
raz
the springs will work , you will have to cut the recoil spring to the size of the original spring
but will work
NORM
the springs will work , you will have to cut the recoil spring to the size of the original spring
but will work
NORM
NORMSUTTON@AOL.COM
N.R.A. LIFE MEMBER 1976
N.R.A. LIFE MEMBER 1976
FEG SMC 918
Thanks, folks. So far it is working fine...I'll need to see if Dennis can do grips with a thumb rest.
raz
raz
FEG SMC 918
He has these. http://www.marschalgrips.com/
The 22# Wolff recoil spring for the P-64 will work, but you must cut about 1 coil off of it.
Mags are just about impossible to find, but the PA-63 mags work, they just hang down.
Hoosier Gun Works claims they have 4 Triple K mags with finger extensions for $22 each. About half way down the page.
http://www.hoosiergunworks.com/catalog/ ... istol.html
The 22# Wolff recoil spring for the P-64 will work, but you must cut about 1 coil off of it.
Mags are just about impossible to find, but the PA-63 mags work, they just hang down.
Hoosier Gun Works claims they have 4 Triple K mags with finger extensions for $22 each. About half way down the page.
http://www.hoosiergunworks.com/catalog/ ... istol.html
Last edited by pshootr on June 15th, 2009, 3:40 am, edited 1 time in total.
FEG SMC 918
Thanks again. I've got Dennis' grips on my P64 and two CZ82s. I'd like a thumb rest for the P63 or SMC918. Maybe I can talk him into making them. I've used the 63 mags....sort of awkward.
Is the SMC 380 or the Triple K" the same mag as the 918?
raz
Is the SMC 380 or the Triple K" the same mag as the 918?
raz
FEG SMC 918
As long as it is a 6 round FEG mag for either the .380 or Mak it should be the same. The .380 and 9mm Mak use the same mag. They are either 6 round for the small frame guns or 7 round for the standard size pistols.