CHANGING HAMMER SPRING
Posted: September 2nd, 2007, 7:05 am
take off grips
cock the hammer , there is a hole in the hammer strut
put a strong wire in it
then pull the trigger allowing the hammer to go forward
then push the hammer spring pin out
you should have the spring, hammer strut, and mag release all in one piece
next lock it up in a vise if you don't have a vise you can use a pair of vise grips
take a small pair of vise grips and clap down on the mag release, then press down , pull the wire out let up on the mag release take out spring put new spring in press down on mag release put wire back in
put spring, hammer strut, and mag release back in gun, put hammer spring pin , cock hammer pull wire out
NORM
cock the hammer , there is a hole in the hammer strut
put a strong wire in it
then pull the trigger allowing the hammer to go forward
then push the hammer spring pin out
you should have the spring, hammer strut, and mag release all in one piece
next lock it up in a vise if you don't have a vise you can use a pair of vise grips
take a small pair of vise grips and clap down on the mag release, then press down , pull the wire out let up on the mag release take out spring put new spring in press down on mag release put wire back in
put spring, hammer strut, and mag release back in gun, put hammer spring pin , cock hammer pull wire out
NORM