Failure / Damage Around Chamber

Mods and Fixes by P-64 users...
Post Reply
Leg097
Posts: 3
Joined: December 12th, 2017, 2:10 pm

Failure / Damage Around Chamber

Post by Leg097 »

Went out and shot some brass cased ammo at the range. Went through two mags, fired the first round on the third and the slide was locked all the way to the back. Striped the pistol down and out fell one half of the ejector. That part I can replace, but I noticed that there were cuts and dents in the metal around the chamber. In particular one on the inside edge of the chamber. Attached are photos, and sorry for the poor quality. Are there options for reversing this sort of damage?

Also, Merry Christmas everyone.

Image
Image
Image
User avatar
Curly1
Elite member
Elite member
Posts: 2529
Joined: September 20th, 2011, 11:35 pm
Location: Upstate NY

Re: Failure / Damage Around Chamber

Post by Curly1 »

Welcome to the forum.

There have been a couple of posts on this subject in the past if you do a search.

Here's an example.

viewtopic.php?f=1&t=4301&p=42122&hilit= ... age#p42122
Laugh Hard and Often.

Gary
Leg097
Posts: 3
Joined: December 12th, 2017, 2:10 pm

Re: Failure / Damage Around Chamber

Post by Leg097 »

Thanks. I'll be sure to read up the threads on this.
Post Reply