Trigger pin locks up my slide

Mods and Fixes by P-64 users...
Post Reply
kwillindy
Junior member
Posts: 14
Joined: January 1st, 2017, 3:19 am

Trigger pin locks up my slide

Post by kwillindy » August 27th, 2017, 12:28 pm

Please see pic. When reassembling, the pin shown had slid out a bit to the left. Hung up my slide real good, thought I might have a gunsmith bill in my future. I manhandled the slide off, and was able to rotate this pin to fully seat it. Kinda mad about scratching it in the process.
Anyway, it seems to be shaped to fit only one way. Is this correct, and does it look fully seated? Manual slide action works fine. Is this a common problem to watch out for? Thanks.
IMG_4591.JPG
P-64 trigger pin

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests