Please see pic. When reassembling, the pin shown had slid out a bit to the left. Hung up my slide real good, thought I might have a gunsmith bill in my future. I manhandled the slide off, and was able to rotate this pin to fully seat it. Kinda mad about scratching it in the process.
Anyway, it seems to be shaped to fit only one way. Is this correct, and does it look fully seated? Manual slide action works fine. Is this a common problem to watch out for? Thanks.
Mods and Fixes by P-64 users...
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests