Page 1 of 1

1st post. Hello and a magazine question.

Posted: April 21st, 2015, 5:12 pm
by jimdgreat1
Traded for a 1968 P64 recently. Really like this pistol. Seem to have received a new style magazine with this pre-72 pistol. I've read to shorten the feed rails. Searched for an actual dimension but have not found one.

Anyone want to measure their old style feed lips with a caliper and give me the length in .001?

It would help rather than guessing.

Re: 1st post. Hello and a magazine question.

Posted: April 22nd, 2015, 4:30 pm
by jimdgreat1
Well I guessed and ground the feed lips back to .68 long. Didn't measure before, should have. Took off maybe .05? .1?
Pistol runs much better now. Still would like to hear measurements from others.

Ordered another from classic. Should have 2 more mags to compare too.

Re: 1st post. Hello and a magazine question.

Posted: April 22nd, 2015, 6:07 pm
by jimdgreat1
This thread was worthless without pics.

Image

Re: 1st post. Hello and a magazine question.

Posted: April 23rd, 2015, 12:16 pm
by craig
Nice gun. I'm sorry I didn't have the measurements you needed., Welcome to the group.

Re: 1st post. Hello and a magazine question.

Posted: April 27th, 2015, 4:38 pm
by jimdgreat1
Bought and received today a 2nd P64 with two magazines. One old and one new style.
New style lip length .730
Old style lip length .660

There is a radius at the end of the lip. Makes exact measuring more of a guess. Looks like I guessed pretty close. I didn't add back the radius but will. Hope this helps someone.

Re: 1st post. Hello and a magazine question.

Posted: May 19th, 2015, 11:37 pm
by jimdgreat1
Found parts for 2 more mags, everything but the finger rest bottom plate. Parts were on gunbroker. Received new old style mag bodies, springs, and followers. Made bottom plates out of aluminum on the mill. Wanted mags without the finger rest.

Image