kilt1irono
I had a similar problem with mine. Trigger will not reset. I would suggest to push/pull the slide back about 1/16 to 1/4 off an inch back, you should hear the disconnector go into the slide and the trigger should work in DA/SA. I was having this problem when decoking the gun. The disconnector willl not move up into the slide. I did file some burrs from the side of the disconnector and polished a little bit. But still had the problem. Look at your slide where the disconnector rides. Some metal may have raised from the area where the hammer gets cocked and could be interferring with the disconnector movement. Also see if there is a burr where the disconnector rides in the slide slot. Mine had one and I removed with a file. So far is working good during my first shooting section. The gun was like that when I received it from AIM.
