Page 1 of 1

Issues with slide and mag eject

Posted: February 17th, 2011, 6:06 pm
by xXPerfecto
OK i have a polish p-64 1974. if i put an empty mag in the pistol and pull the slide back it locks in place. thats fine. but it takes everything i have to get the mag out. when i put the mag back in and pull the slide back it locks in place and will not move. the pistol works fine with no mag in. someone please help. i can post pics if that helps.

thanks
Justin

Re: Issues with slide and mag eject

Posted: February 18th, 2011, 7:45 am
by normsutton
Justin

sounds like the wrong mag, pix should help

NORM

Re: Issues with slide and mag eject

Posted: February 18th, 2011, 8:05 am
by xXPerfecto
i almost sure there the right mag. i have two mags and the problem is with both. i think there might be a issue with the slide stop spring. but i have no idea where to begin. the slide lock leaver is getting stuck in the wrong postion. (i think). ill post pics of the issue and the mags when i get home later Edit: i have some now but not of the jam. Image

Re: Issues with slide and mag eject

Posted: February 19th, 2011, 8:24 am
by normsutton
Justin
ok, seem to be the right mags, you cleaned the gun right of all cosmoline,

NORM

Re: Issues with slide and mag eject

Posted: February 19th, 2011, 9:25 am
by xXPerfecto
i started on that last night. i will post back with the results

thanks
Justin

Re: Issues with slide and mag eject

Posted: February 21st, 2011, 4:23 pm
by xXPerfecto
WOW.... :D that did the trick... im kinda a noob with the old guns

thanks for all the help...

Re: Issues with slide and mag eject

Posted: February 27th, 2011, 5:11 pm
by blinddog
A clean pistol is a good pistol!