Page 1 of 1

I am confused with the sequence

Posted: April 10th, 2017, 1:35 am
by rvenneman
I am going to start converting 9x19 to 9x18 cases. Would this be the proper sequence:
1. Tumble.
2. Deprime/case shaper with 9x18 die.
3. Expand to accept 9x18 size (.365) bullet.
4. Trim case to 9x18.
5. Charge case.
6. Seat bullet

Is this the sequence to use?

Thanks

Re: I am confused with the sequence

Posted: June 22nd, 2017, 11:06 am
by normsutton
3. Expand to accept 9x18 size (.365) bullet.
4. Trim case to 9x18.
changes these steps to it should work better
.
3. Trim case to 9x18.
4. Expand to accept 9x18 size (.365) bullet
NORM