Brass trimming...

[juniustaylor]

Figured out my allen wrench mount. I took two of the sticky back magnets like I use on my tooled leather fridge magnets that I make. Stuck them back to back. So, they are thick enough that they will stick to the nut on the backside of the chuck and the wrench then sticks to the magnet. So, that problem is solved. Got it all mounted to a piece of wood and C-clamped to my bench. Nice and sturdy.

[The Only Sarge]

Lil picture walk thru....I got the LE Wilson 9mm case gauge and man I am sticking with this versus the Lee method. I have used my LE Wilson case trimmer in the past for rifle loads but thought I'd try it for the Luger to Mak case conversion.
I run the Luger case through the Lee full length resizer and pops the primer out of course....

Pop it in the case gauge and run it a few turns....


After 75 cases it is dead ringer still on .710-.7095