Quick question...about trigger bar

115grfmj · Post by **115grfmj** » January 29th, 2007, 11:03 am

I don't have the ability to post pictures, so I try to explain this a clear as possible. On the left side of the gun (where the slide stop is). The trigger pin that holds the trigger in, has a flat spot like a foot on the end (probably so you can only push the pin out from the right side). Any way on mine the "foot" protrudes beyond the slide stop, so that it is on top of the slide stop, and the pin doesn't come all the way thru the hole on the other side. My question is the pin supposed to beflush with the frame and under the slide stop, or is this normal. I doesn't seem to be interfering with the function? But I'm just curious.

Post by **normsutton** » January 29th, 2007, 12:41 pm

115grfmj

There is a slot for the foot to fit in and sould be flush with the frame

NORM

115grfmj · Post by **115grfmj** » January 29th, 2007, 1:29 pm

Thank you sir..........do you happen how I would go about removing the slide stop, to fit the trigger properly?

Thanks Again

Post by **normsutton** » January 29th, 2007, 2:04 pm

115grfmj

the slide stope dosn't fit on the trigger

the trigger bar dose send me your email address and i'll send you a diogram how the trigger bar goes on

NORMSUTTON@AOL.COM

NORM

115grfmj · Post by **115grfmj** » January 29th, 2007, 9:06 pm

Thanks Norm.....your the best! ;D

Post by **normsutton** » January 29th, 2007, 9:28 pm

115grfmj

Glade I could help
and glade you could understand what I wrote in previous post , I just reread it and I don't (LOL)

NORM

The Unofficial P64 Resource Forum