How to install back the trigger bar ?

Info, pictures, advice...
Post Reply
najaf
Member
Member
Posts: 52
Joined: September 12th, 2006, 6:51 pm

How to install back the trigger bar ?

Post by najaf » October 18th, 2006, 6:34 pm

For some reason i was fiddling with my P64 and cocked the hammer and removed the slide . I pulled the trigger and the hammer fell. I recocked the hammer and the problem started. I pulled trigger and the hammer stayed cocked. I proceeded to remove both grips and tried pulling trigger several times but hammer stayed cocked. In the course of pulling the trigger the trigger bar came off. I dont why it did. I have no idea how to put this back (not machinically savvy). I see the the trigger bar has two jutting protrusions which goes to the trigger side that has holes. I wish I have another P64 so I can compare to have an idea to reassemble.
Can someone help me go thru steps in this regard. Thanks

najaf
Member
Member
Posts: 52
Joined: September 12th, 2006, 6:51 pm

How to install back the trigger bar ?

Post by najaf » October 18th, 2006, 6:38 pm

I was trying to find a pictorial diagram here on the P64s right side showing the trigger bars right placement but found only left side schematics. Maybe someone here can help. thanks

User avatar
normsutton
Global moderator
Global moderator
Posts: 3559
Joined: February 26th, 2006, 6:59 am
Location: LAKELAND FL.
Contact:

How to install back the trigger bar ?

Post by normsutton » October 18th, 2006, 8:11 pm

najaf

Ether the trigger return spring broke or came of the off the trigger bar
give me your email address and I'll sent you a print out

of what to look for




NORM
NORMSUTTON@AOL.COM
N.R.A. LIFE MEMBER 1976

ImageImage

stibnite
Member
Member
Posts: 103
Joined: January 23rd, 2006, 10:56 pm

How to install back the trigger bar ?

Post by stibnite » October 18th, 2006, 10:21 pm

najaf -

Can you post a follow-up later? It might help others with the same problem.

najaf
Member
Member
Posts: 52
Joined: September 12th, 2006, 6:51 pm

How to install back the trigger bar ?

Post by najaf » October 18th, 2006, 10:46 pm

I followed normsutton's step by step pictorial and its back now. I appreciate for your prompt help sir. I thought I had a broken hammer return spring but it wasnt at all. it took me a mindbuggling 4 hrs to feature how it put it back.
Another easy way I used is a small cabinet nail to depress the tail of the return spring working on the rt side trigger hole and slowly position the trigger bar in place. MAke sure you cock the hammer and the trigger bar tail end will just fall in place.
I hope my trigger return spring will hold on for now and if it does broke, I will order from normsutton. Thanks again.

bzinggg
Forum supporter
Forum supporter
Posts: 487
Joined: May 30th, 2006, 2:17 pm
Location: Texas

How to install back the trigger bar ?

Post by bzinggg » October 18th, 2006, 11:03 pm

In the Manual, which is available for download right here on this forum, it says "Do not allow the hammer to fall with the slide removed. Damage to the mechanism may result." (Page 9 in the manual, page 5 of the PDF file.)

It is so important to read the manual on each different firerarm that you own, BEFORE you operate or dissassemble it.

Post Reply