Is my p64 shot?

Info, pictures, advice...
Post Reply
jasontaylor
Posts: 5
Joined: July 31st, 2009, 6:44 pm

Is my p64 shot?

Post by jasontaylor » August 4th, 2009, 7:20 pm

As I was changing out the hammer spring I took a good look at the hammer strut. The engagement surface is worn to the point of metal hooking or forming a wire edge around it. Its a 70 model with good clean rifleing but some obvious ware and tear. Any expert opinions on this? It has functioned just fine for over 300 rounds as long as the springs are stock.

Post Reply