Search found 6 matches
- March 6th, 2018, 3:06 pm
- Forum: Modifications, Fixes, and Repairs
- Topic: Failure to feed
- Replies: 13
- Views: 11399
Re: Failure to feed
Well I tried the other mag and it jammed on the last round. I THINK, but I'm not positive, that the slide was hanging up on the extractor. I had to put the slide against a table and shove downwards to dislodge it and have it close again. I'm thinking I won't shoot it again until I've had time to do ...
- March 6th, 2018, 4:00 am
- Forum: Modifications, Fixes, and Repairs
- Topic: Failure to feed
- Replies: 13
- Views: 11399
Re: Failure to feed
Oh no offense taken. I've worked in customer service for about 6 years now, I know just how dumb people can be.
- March 5th, 2018, 10:49 pm
- Forum: Modifications, Fixes, and Repairs
- Topic: Failure to feed
- Replies: 13
- Views: 11399
Re: Failure to feed
Well it's out of a box labelled 9mm Makarov so I actually fired a mag of the same rounds previously.
I finally bit the bullet and went in there and just pried it up, so it's good now. Tomorrow I'll try shooting again and see if it happens again.
Was 9mm Mak usually steel or brass cased?
I finally bit the bullet and went in there and just pried it up, so it's good now. Tomorrow I'll try shooting again and see if it happens again.
Was 9mm Mak usually steel or brass cased?
- March 5th, 2018, 10:09 pm
- Forum: Modifications, Fixes, and Repairs
- Topic: Failure to feed
- Replies: 13
- Views: 11399
Re: Failure to feed
The round is pretty much lodged, it doesn't give at all when I push on the rim, even when I push down on the next round.
How bad of an idea would it be to tap on the rim of the round?
How bad of an idea would it be to tap on the rim of the round?
- March 5th, 2018, 8:08 pm
- Forum: Modifications, Fixes, and Repairs
- Topic: Failure to feed
- Replies: 13
- Views: 11399
Re: Failure to feed
I can't move it easily and I'm slightly worried about trying to force it. I don't want to bend the lips.
- March 5th, 2018, 6:00 pm
- Forum: Modifications, Fixes, and Repairs
- Topic: Failure to feed
- Replies: 13
- Views: 11399
Failure to feed
So I went to ping some steel and this happened. Any ideas on how to fix it? The round that's partially fed keeps the magazine from dropping so I can't do that.