Search found 3 matches

by jhm123
August 7th, 2006, 5:08 pm
Forum: General P-64 Discussion
Topic: polishing feed ramp...
Replies: 8
Views: 5840

polishing feed ramp...

truth: I've always used the rouge marked "Stainless" (I believe it's 2nd finest available) on carbon steel. There are a bunch of different Dremel pads & the only one I've found soft enough are the white, round ones that "screw" on to the arbor. If it's a little large, you can...
by jhm123
August 3rd, 2006, 5:18 pm
Forum: General P-64 Discussion
Topic: How good are these little handguns?
Replies: 7
Views: 5711

How good are these little handguns?

scbackpacker:

Defintely a quality weapon & an even better value. Proper prep work is key to most any finish, but on most of the 64's I've seen, the bluing looks great (my preference in a handgun finish).

Far as the coatings, I've only worked w/ Gun Kote, but so far so good.

JHM
by jhm123
July 14th, 2006, 9:18 pm
Forum: Sticky Book
Topic: 9mm mak stopping power vs 38 special?
Replies: 54
Views: 68985

9mm mak stopping power vs 38 special?

Evenin' Folks: Read some good stuff through this thread. I've done ad-hoc testing w/ wet-pack, jello bag's, etc. & the stuff you hear about hollow-point ammo needing >800fps to expand is pretty much true...I'd say 830-850fps to be safe. Almost no non +P .38 Spec round will hit 850fps w/ any reas...